In Baltimore the roof you have decides the scope: flat, low-slope, slate, or a mix, often sharing a wall with a neighbor.
Only about 45.4% of Baltimore metro housing units are single-family detached, according to ACS estimates, and about 55.7% were built before 1980. That means a large share of roofs sit on rowhouses and semi-detached homes, where the roof is often flat or low-slope, shares a parapet wall with a neighbor, and has been repaired in sections rather than replaced.
Ask what roof type and covering the proposal addresses: built-up or modified bitumen on a flat, asphalt shingle on a slope, slate or tile on an older pitched roof. Each has different repair methods, expected service life, and skill requirements. A contractor who mostly installs shingles may not be the right one for a low-slope roof.
In attached housing the most common leak points are junctions: where the roof meets a shared wall, where a parapet cap has failed, and where a chimney passes through. Ask how these details are addressed, whether counter-flashing is replaced or reused, and how work is coordinated with a neighbor when the wall is shared.
Ask whether the quote is for a full tear-off or an overlay, how many existing layers are present, and what happens if the decking is found to be soft. The condition of the sheathing is unknown until the old roof comes off, so ask how that discovery is priced and approved.
Ask how the roof assembly ventilates and how attic or ceiling moisture is handled. In older homes with bathroom fans discharging into an attic, the deck can stay wet from the inside — a problem a new roof does not fix. Ask whether ventilation and exhaust corrections are in scope.
- Which roof areas and coverings does this scope address? - Are party walls, parapets, and counter-flashing included? - Is this a tear-off or an overlay, and how many layers exist? - How will unexpected decking damage be priced and approved? - Is ventilation or exhaust correction part of the scope? - Do you handle permits, and are historic-district rules involved?
This page does not inspect a roof or estimate cost for a specific property. Roof condition, permit requirements, and historic-district rules vary by address and jurisdiction, and should be confirmed on site and with the responsible local authority.
The 2024 ACS 5-year estimates put the metro at about 2.8 million residents and 1.1 million households. About 66.9% of occupied homes are owner-occupied, and about 45.4% of housing units are single-family detached, so most households live where roof work touches shared walls or shared structures. About 55.7% of housing units were built before 1980. This page reports Census indicators only; a NOAA station is not included for this metro in the site dataset.
| Indicator | Value | Source |
|---|---|---|
| Metro population | 2,849,436 | U.S. Census Bureau |
| Households | 1,120,269 | U.S. Census Bureau |
| Owner-occupied share | 66.9% | U.S. Census Bureau |
| Single-family detached share | 45.4% | U.S. Census Bureau |
| Housing units built before 1980 | 55.7% | U.S. Census Bureau |
Census values describe the metro area, not an individual property. A climate station is not reported for this metro in the site dataset.
Reviewed on 2026-11-18.