The oldest housing stock on this site means the heating system is often original and the cooling system does not exist yet.
With 73.1% of metro housing built before 1980, and much of the city's stock predating the Second World War, Pittsburgh's heating systems were installed before ductwork was standard practice. Hot water radiators, steam radiators and a boiler in the basement are still the norm in many neighborhoods, and they work well. The complication is everything else: cooling, ventilation and filtration all want ducts, and a brick rowhouse on a hillside has no chases to put them in. That is why the local conversation usually splits into keeping the hydronic system and solving cooling a different way.
A working hydronic system is quiet, comfortable and inexpensive to keep running relative to replacement. The essential distinction is steam versus hot water: they are maintained differently, and a contractor who treats one as the other will misdiagnose the problem. Ask which system the house has, what the boiler's condition and combustion test show, whether the radiators will be balanced, and what the basement provides in venting and combustion air. If replacement is proposed, ask why and what happens to the distribution system.
The three realiztic routes are conventional ducts through chases and dropped soffits, high-velocity small-duct systems, and ductless mini-splits serving individual rooms. Each has trade-offs. Small-duct systems need careful design and do not expand casually; mini-splits heat and cool room by room unless the layout is planned; conventional ducts in a plaster-and-brick house mean visible compromise somewhere. Ask how many heads or outlets are proposed, which rooms they serve, what happens to the rooms left out, and where the outdoor unit can sit without upsetting a neighbor or a historic facade.
Houses built into a slope often have three or four levels with different heat loss characteristics and no natural circulation between them. That makes zoning more important than raw capacity: a single thermostat in a hallway cannot serve a house arranged like that. Ask how the proposal addresses the levels individually, whether separate zones or heads are proposed, and how the system behaves on the coldest nights when the upper floors are warmest from rising heat.
January averages 28.8°F at the airport station and 44.1 inches of snow falls in a typical year, so heating runs for months. That makes combustion efficiency worth attention: a boiler or furnace that has never been tuned is running below its potential, and combustion testing is a safety check as well as an efficiency one. Ask what the seasonal service includes — combustion analysis, heat exchanger inspection, expansion tank and relief valve — and whether the chimney or flue has been inspected, since masonry chimneys in old houses are often in poor condition.
Equipment fails when it works hardest, and the first sustained cold snap is also when every contractor's schedule is full. Autumn service on the heating side, spring on the cooling side, and a clean filter schedule cover most of the risk. Ask what the visit includes and whether priority scheduling is part of the agreement, and keep the report, because a documented service history is useful when the equipment eventually fails.
- Is the system steam or hot water, and what is the evidence for that diagnosis? - What do combustion testing and the heat exchanger inspection show? - If cooling is being added, which approach, and which rooms are served? - How are the multiple levels of the house zoned? - What is the design heating load, and at what outdoor temperature? - Has the chimney or flue been inspected, and what did it show?
No prices and no equipment recommendations are published here. Sizing, combustion safety and refrigerant work require on-site assessment by a licensed professional, and permit and historic-district questions belong to the local authority.
ACS 2024 5-year estimates describe about 2.44 million residents in 1,061,705 households and 1,174,149 housing units, with 70.7% owner-occupied and 68.0% single-family detached. About 73.1% of units were built before 1980 — the oldest stock on this site — which is why boilers, radiators and ductless retrofits dominate. NOAA's station records January at 28.8°F, July at 73.2°F and 44.1 inches of annual snowfall.
| Indicator | Value | Source |
|---|---|---|
| January mean temperature | 28.8°F | NOAA NCEI |
| July mean temperature | 73.2°F | NOAA NCEI |
| Annual snowfall | 44.1 in. | NOAA NCEI |
| Annual precipitation | 39.6 in. | NOAA NCEI |
| Housing units built before 1980 | 73.1% | U.S. Census Bureau |
| Single-family detached share | 68.0% | U.S. Census Bureau |
Monthly means are 30-year station averages. A design load uses a colder outdoor condition than the January mean and must be calculated for the specific building.
Reviewed on 2026-11-18.