Solar Panels in Seattle: Winter Output and What to Compare

Solar works in Seattle, but the output curve is extreme: long summer days and very little in December and January.

Seattle's solar story is about seasonality. The metro sits far north, so summer days are long and winters are short and overcast — July at Sea-Tac averages 67.1°F and about 0.6 inches of rain, while the annual total is about 39.3 inches, most of it between October and April. A system that produces well in June may produce very little in December, and the estimate should show both.

Ask for a monthly production curve

A single annual number hides the shape of the year. Ask for estimated production by month, and compare it with the household's actual consumption by month. If the household uses most of its electricity in winter, a summer-heavy solar profile changes the value calculation — and that should be visible in the proposal.

Evergreens and low winter sun

Ask how shade was measured and whether the analysis covers winter sun angles, when the sun is low and evergreens cast long shadows. Ask which roof planes are proposed and whether module-level electronics are used to reduce the effect of partial shade. A summer-only shade check misses the hardest part of the year.

Moss, rain, and roof condition

Roofs here stay wet for months, and moss is common on shaded slopes. Ask how the installer evaluates roof condition and moss before mounting, how penetrations are flashed and sealed, and who pays if the roof needs work later. About 42.7% of metro housing units predate 1980, according to ACS estimates, so some roofs are older than the system would be.

Inverters, batteries, and winter

Ask where the inverter will be mounted and whether its operating range suits an exterior wall in a damp climate. If battery storage is proposed for winter outages and low production, ask what the battery can actually carry and for how long during a December storm.

Questions to ask before signing

- What is the estimated production by month, not just per year? - How does that curve compare with our consumption by month? - Was shade measured for low winter sun angles? - How is roof condition and moss evaluated before mounting? - Where will the inverter and any battery be mounted? - Who pays for removal and reinstallation if the roof is replaced?

Where this page stops

This page does not estimate production, savings, or payback for a specific property and does not confirm which incentives apply. Those depend on the roof, shading, equipment, utility rules, and current tax law, which should be checked with the relevant official source.

Seattle metro context

The 2024 ACS 5-year estimates put the metro at about 4.1 million residents and 1.6 million households. About 60.0% of occupied homes are owner-occupied, and about 56.0% of housing units are single-family detached, a lower share than most metros in this set, so more households share a roof decision with a building or association. NOAA's Sea-Tac station records January averaging 42.8°F, July 67.1°F, and about 39.3 inches of precipitation a year.

Seattle reference station and housing indicators

NOAA NCEI 1991–2020 normals for Seattle–Tacoma International Airport (USW00024233); U.S. Census Bureau ACS 2024 5-year estimates.
IndicatorValueSource
January mean temperature42.8°FNOAA NCEI
July mean temperature67.1°FNOAA NCEI
July precipitation0.6 in.NOAA NCEI
Annual precipitation39.3 in.NOAA NCEI
Metro population4,061,920U.S. Census Bureau
Owner-occupied share60.0%U.S. Census Bureau

Station normals are historical averages for one location, not a forecast. Census values describe the metro area, not an individual property.

Frequently Asked Questions

Is solar worth it in Seattle?

It can be, but the seasonal shape matters. Ask for monthly production estimates and compare them with the household's monthly consumption, including winter, before judging payback.

How much does solar produce in winter here?

Much less than in summer because days are short and skies are often overcast. The proposal should show the monthly curve rather than an annual average.

Should I fix my roof or remove moss before installing solar?

If the roof is near the end of its service life or has heavy moss, it is usually cheaper to address it first. Ask how roof condition is evaluated and who is responsible for removal and reinstallation later.

What should I compare between solar quotes?

Compare the gross cash price, system size, equipment models, monthly production estimates and assumptions, included roof and electrical work, exclusions, and each warranty.

Who handles permits and utility interconnection?

It varies by contract. Ask which party prepares the permit and interconnection application, who schedules inspections, and who confirms permission to operate.

What is the population of the Seattle metro area?

The U.S. Census Bureau's 2024 ACS 5-year estimates report about 4.1 million residents in the metro area. The figure describes regional scale, not the number of homes or providers.

Sources and review date

Reviewed on 2026-11-17.

Other Home Services in Seattle–Tacoma–Bellevue