Memphis, TN-MS-AR · metro guide
Plumbing in Memphis: Clay Soil, Crawl Spaces, and Cast Iron Drains
The two failures that show up most often here are a pipe in a vented crawl space and a cast iron drain under a slab.
Metro snapshot
Memphis in numbers
Sources named below each block
- Population
- 1.3M
- Households
- 523K
- Housing units
- 580K
- People / household
- 2.57
- population ÷ households
Owner-occupied homes 61%
The rest are rented. Owners are the ones who commission most exterior work.
Single-family detached 70%
Detached houses carry their own roof, gutters and exterior walls.
Built before 1980 46%
Older housing stock shapes what fails first: gutters, flashing, pipe material.
Season
The year in Memphis
- Precipitation
- 54.9 in
- Snowfall
- 2.7 in
Average temperature by month, °F — the shape of the year is what decides when exterior work gets done.
Precipitation by month, inches.
Snowfall by month, inches.
| Month | Average temperature (°F) | Precipitation (in) | Snowfall (in) |
|---|---|---|---|
| January | 42.1°F | 4.14 in | 0.9 in |
| February | 46.1°F | 4.55 in | 1.0 in |
| March | 54.2°F | 5.74 in | 0.5 in |
| April | 63.2°F | 5.87 in | 0.0 in |
| May | 72.1°F | 5.27 in | 0.0 in |
| June | 79.9°F | 3.99 in | 0.0 in |
| July | 82.8°F | 4.82 in | 0.0 in |
| August | 82.1°F | 3.37 in | 0.0 in |
| September | 76.0°F | 3.03 in | 0.0 in |
| October | 64.6°F | 3.98 in | 0.0 in |
| November | 52.7°F | 4.69 in | 0.1 in |
| December | 44.8°F | 5.49 in | 0.2 in |
NOAA 1991–2020 climate normals, station MEMPHIS INTL AP, TN US (USW00013893). Station observations, not a metro-wide average — a metro that spans a mountain range can differ by more than this record shows.
Population, households and housing shares: U.S. Census Bureau, American Community Survey 2024 5-year estimates, metropolitan statistical area.

Plumbing in Memphis is shaped by the ground and by the way houses here are built on top of it. Much of the metro sits on clay and loess soils that swell when wet and shrink when dry, and that movement works on buried lines year after year. At the same time, a large share of the housing has a vented crawl space rather than a basement, with supply and drain lines running underneath the floor in open air. The result is a pair of very local failure modes: a sewer lateral that has been pulled apart by soil movement, and a supply line that freezes in a crawl space during the one hard cold snap of the winter.
Soil movement and the sewer lateral
When clay shrinks in a dry summer and swells after heavy rain, buried pipe that was laid with a gentle slope can shift, separate at a joint or develop a belly where water stands. Grease and paper collect at that low point, and the drain that was fine last year backs up this year. Recurring clogs at one fixture, gurgling, and sewage odors in the yard are the usual signals. A camera inspection is the only way to know what condition the line is in; ask for the recording and for defect locations measured from an accessible point so a second opinion starts from facts.
Pipes under a vented floor
Crawl space foundations are common in the older parts of the metro, and the plumbing under them is exposed to the outside air through the foundation vents. That is fine for most of the year and a problem during a hard freeze, when the wind gets under the house and a line in the wrong place splits. Insulating and heat-tracing the vulnerable runs, closing or shielding vents during cold snaps, and knowing where the main shutoff is are the practical measures. Ask which lines run under the house, whether they are insulated, and whether any of them sit near an open vent.
Cast iron drains and their slow decline
Houses built in the middle of the last century often have cast iron waste lines that have been rusting from the inside for decades. The early signs are rough pipe visible on camera, repeated clogs in one part of the system, and staining on a ceiling below a bathroom. Replacing a section is often sensible; replacing the whole stack is a different conversation. Ask what the inspection found, where the defect is, how much of the run is affected, and whether the proposal replaces a section or the system. A patch that leaves the worst of the pipe in place is a patch you will meet again.
Pressure and the fixtures downstream
Pressure arriving from the municipal system can be high enough to wear out valves, hose bibs and irrigation components, and its effect is cumulative and invisible until something fails. A pressure-reducing valve at the service is standard on newer construction and can be missing or failed on older homes. Ask whether the pressure has been measured and what it reads, whether a regulator is fitted and set correctly, and whether the hose bibs and angle stops were checked while the plumber was on site. These are the components that fail at the least convenient moment.
Hard water and the water heater
Water hardness varies across the region and by source, but where it is high the visible effect is scale on fixtures and the expensive effect is a tank that heats through sediment. Flushing the tank annually is the cheapest intervention available, and it is routinely skipped. Ask when the water heater was last flushed, whether the anode rod has been inspected, and whether the pan and its drain are intact — in a house with a crawl space or a garage installation, a leaking tank becomes a much larger repair than the tank itself.
Questions for a plumbing estimate
Where this page stops
This page does not diagnose a system and publishes no prices. Gas work, sewer work and water heater installation require a licensed plumber and, depending on the address, a permit and inspection.
Memphis metro context
ACS 2024 5-year estimates report about 1.34 million residents in 522,879 households and 580,185 housing units, with 60.5% owner-occupied and 69.9% single-family detached. About 46.1% of units predate 1980, which is the share where cast iron drains, original crawl space plumbing and galvanized supply are most likely to survive. A climate station is not reported for this metro in the site dataset, so no temperature figures appear on this page.
Memphis housing and ownership indicators
| Indicator | Value | Source |
|---|---|---|
| Housing units built before 1980 | 46.1% | U.S. Census Bureau |
| Single-family detached share | 69.9% | U.S. Census Bureau |
| Owner-occupied share | 60.5% | U.S. Census Bureau |
| Metro households | 522,879 | U.S. Census Bureau |
| Housing units | 580,185 | U.S. Census Bureau |
| Metro population | 1,341,924 | U.S. Census Bureau |
No climate normals are shown because no station record is held for this metro in the site dataset. Soil conditions vary locally, and a camera inspection is the only reliable way to judge a buried line.
Frequently Asked Questions
Why does my drain back up every year?
Recurring blockages usually point to a defect in the pipe rather than a fresh clog: a separated joint, a belly where water stands, or roots at a crack. Clearing the drain restores flow temporarily; a camera inspection identifies the cause.
Can pipes freeze under a house with a crawl space?
Yes, during a hard freeze with wind reaching the foundation vents. Insulating and heat-tracing the vulnerable runs, shielding vents during cold snaps, and knowing the main shutoff location all reduce the risk.
Do I need to replace all the cast iron at once?
Not necessarily. What matters is the condition of the pipe throughout the run, which a camera inspection establishes. Replacing the worst section may be reasonable, but a proposal that leaves severely deteriorated pipe in place will lead to another repair.
How often should a water heater be flushed?
Annually where the water is hard, which is the cheapest way to extend tank life. Ask about the anode rod at the same time, and confirm that the pan and its drain are intact.
Who is responsible for the sewer line under my yard?
Usually the homeowner up to the connection with the public main, though the exact boundary varies by jurisdiction. Ask the local public works department for the address before approving a repair.
What causes high water pressure?
The municipal supply can deliver more than fixtures are designed for, and a failed or missing pressure-reducing valve lets it through. Measuring the pressure takes minutes and prevents a whole category of leaks.
Sources and review date
- American Community Survey 2024 5-year estimates (CBSA tables) — U.S. Census Bureau, 2024 ACS 5-year estimates.
Reviewed on 2026-11-18.