The sun is adequate. What costs production here is heat, and what costs money is a roof near the end of its life.
Memphis sits in a band where solar works well but not spectacularly, and the limiting factor is not sunshine hours. It is heat. A photovoltaic module loses output as its cells warm, and cells on a roof in a hot, humid summer run far above air temperature, so a production estimate that uses standard test conditions without adjusting for local temperature will overstate the result. Add a housing stock where 46.1% of units predate 1980 and a storm season that brings hail and high wind, and the questions worth asking a Memphis installer are about derating, roof condition and wind rating rather than about how sunny it is.
The temperature coefficient on a module is published and it is not a rounding error in a climate this warm. Heat also interacts with mounting: panels flush against a hot shingle surface run hotter than panels with an air gap and airflow behind them. Ask what cell temperature the model assumed, whether the design allows for airflow, and how the seasonal production profile looks. A quote built from a generic sun-hours figure will not reflect the difference between March and August here.
Severe thunderstorms bring hail and strong straight-line wind, and both put demands on the mounting and on the modules. Ask what the hail impact rating of the equipment is, what wind speed the mounting is engineered for, and how the roof penetrations are flashed. This is also where roof age becomes a financial issue: an array installed on a covering that is nearing replacement will have to be removed and reinstalled after the next storm claim, and that cost falls on the homeowner rather than the insurer in most cases.
Nearly half the housing here was built before 1980, which means a large number of the roofs being quoted are original or first-generation replacements. Before any panel layout is discussed, ask how old the covering is, what the remaining service life is judged to be, and whether the installer will put that judgement in writing. On older houses, the deck and the attic ventilation deserve attention at the same time, because a hot attic shortens the life of the shingles above it, with or without solar.
Older neighborhoods here have mature trees, and a roof plane that looks clear in winter can be shaded for hours in summer when the canopy is full. A shade study should cover the seasons, not one afternoon. Ask which hours of the year were modelled, whether the design uses string inverters or per-panel electronics so that a shaded section does not drag the rest, and what the plan is if a tree is removed or a neighbor builds upward.
How exported energy is credited, what fixed charges remain, and how accumulated credits are treated at the end of a period all change the payback more than a small difference in panel efficiency. Ask who files the interconnection request with the local utility, what the expected review window is, and what the current credit structure is in writing. Confirm it with the utility rather than relying on the installer's summary, since these terms have been revised in many states in recent years.
- What cell temperature and seasonal profile are used in the production estimate? - What are the hail impact and wind ratings of the equipment and mounting? - How old is the roof, and what is its expected remaining life in writing? - Which hours of the year were shaded, and how is the array wired? - Who files interconnection, and what is the current credit structure? - What monitoring is included, and who is accountable if output falls short?
No prices, incentives or production figures are published here, because none can be produced honestly without a site assessment. Roof condition and structural capacity require inspection, and financial and regulatory questions belong to a qualified adviser and the utility.
The 2024 ACS 5-year estimates count about 1.34 million residents in 522,879 households across 580,185 housing units, with 60.5% owner-occupied and 69.9% single-family detached — a high detached share, which means many households control a roof plane suitable for an array. About 46.1% of units were built before 1980. A climate station is not reported for this metro in the site dataset, so no temperature or precipitation normals appear on this page.
| Indicator | Value | Source |
|---|---|---|
| Single-family detached share | 69.9% | U.S. Census Bureau |
| Owner-occupied share | 60.5% | U.S. Census Bureau |
| Housing units built before 1980 | 46.1% | U.S. Census Bureau |
| Housing units | 580,185 | U.S. Census Bureau |
| Metro households | 522,879 | U.S. Census Bureau |
| Metro population | 1,341,924 | U.S. Census Bureau |
No climate normals are shown because no station record is held for this metro in the site dataset. Irradiance and cell temperature have to be modelled for the specific roof.
Reviewed on 2026-11-18.