The sun is not the constraint here — the oak canopy, the roof under the array and the utility's rules are.
Sacramento has excellent sun and one of the highest rates of residential solar in the country, largely because a municipal utility here has supported it for years. That history means the market is mature and the differences between quotes are rarely about the modules — they are about shading, roof condition, electrical capacity and how the system is configured as export rules change. Nearly 44% of the housing predates 1980, and the older neighborhoods are heavily shaded by mature trees, so a production estimate built on a generic model of sun and roof area will not describe the property you actually own.
In the central neighborhoods and the older suburbs, a mature street tree or a valley oak in the yard can shade a roof for most of the day, and the shading gets worse in winter when the sun is low. Module-level electronics can limit the loss from a shaded corner, but they cannot create production that is not there. The honest first step is a shade study rather than a layout. Ask how shading was measured and when, what the design does about the shaded hours, and whether the production estimate accounts for the trees as they will be in ten years.
A solar array is a twenty-five year decision mounted on a covering that may not have twenty-five years left. Removing and reinstalling panels to replace a roof adds cost and labor that no original quote includes, and it puts the penetration seals through a second cycle. On a 1950s or 1960s house the question is sharper, because the deck underneath may already be questionable. Ask the age of the covering, whether the roof will be checked before mounting, what the penetrations will be sealed with, and what the arrangement is if the roof has to be replaced later.
The array connects through the service panel, and older houses may lack either the busbar allowance or the physical space for the breaker. The interconnection application is a separate process with the utility, with its own review and its own timeline, and a service upgrade in front of it adds a utility disconnect and reconnect. Ask what was found at the panel, whether an upgrade is included, and who files the interconnection — because the delay usually sits there rather than in the installation.
Compensation for exported power has been reduced across California, which changes the economics of a system designed to export at midday toward one designed to serve the house in the evening. That pushes design decisions — orientation, sizing and whether a battery is included — into the foreground. Ask what the current compensation arrangement is for the address, how the design accounts for evening use, and whether storage is being proposed because it improves the system or because it is being sold.
The panels go up in a few days; the project does not. A building permit, an electrical permit in some jurisdictions, an inspection, and the utility's interconnection approval all sit around that short installation, and the last of them is usually the bottleneck. Ask who files each application, what the recent timeline has been, and what happens to the schedule if the utility asks for a design change.
- How was shading measured, and does the estimate account for the trees on site? - How old is the roof, and what happens if it needs replacing later? - What is the service capacity, and is a panel or service upgrade included? - Which utility serves the address, and who files the interconnection? - What compensation applies to exported power, and how does the design use it? - Is storage proposed for a stated reason, and what does it change?
No system sizes, prices or production figures are quoted here. Tariffs, interconnection rules and incentive programs change, so current terms should be confirmed with the utility and the state authorities rather than taken from any page, including this one.
The 2024 ACS 5-year estimates describe about 2.43 million residents in 881,889 households and 954,751 housing units, with 63.0% owner-occupied and 68.4% single-family detached — a stock where most roofs are individually owned and individually shaded. About 43.9% of units predate 1980. No climate station is reported for this metro in the site dataset, so no temperature or precipitation normals appear on this page.
| Indicator | Value | Source |
|---|---|---|
| Housing units built before 1980 | 43.9% | U.S. Census Bureau |
| Single-family detached share | 68.4% | U.S. Census Bureau |
| Owner-occupied share | 63.0% | U.S. Census Bureau |
| Metro households | 881,889 | U.S. Census Bureau |
| Housing units | 954,751 | U.S. Census Bureau |
| Metro population | 2,426,388 | U.S. Census Bureau |
No climate normals are shown because no station record is held for this metro in the site dataset. Roof age and tree cover vary street by street, which is why production should be modelled for the site rather than estimated from a metro average.
Reviewed on 2026-11-18.